Oil with additives or detergent will damage tool parts. Page 9: Actuating Tool Never load nails with the contact trip or trigger activated. Personal injury may result. DO NOT load fasteners strip into magazine backwards. Read all Safety Warnings before using tool.
Connect the tool to air supply. Page 10 Sequential action trigger - Fig. Page 11 To drive a nail deeper, rotate the depth setting wheel G to the left. Test fire another fastener and check depth. Repeat as necessary to achieve desired results. The amount of air pressure required will vary depending on the size of the fastener and the material being fastened.
Page 12 Keep tool as warm as possible prior to use. Make certain all fasteners have been removed from magazine. Lower air pressure to 80 psi or less. Page Maintenance For assistance with your tool, visit our website at www.
ServIce replacement partS Use only identical replacement parts. Be sure to include all of the information shown on the nameplate of your tool model number, type, serial number, etc.
Page Troubleshooting Guide Clean magazine. Driver tip is worn or Install Driver Maintenance Kit. Page 16 Compressor will be sufficient for tools at all production rates. Compressor will be sufficient at slow or moderate production rates, but may have difficulty at very rapid rates.
Compressor will be adequate only when tools are utilized at slow production rates punch-out or occasional use. I fig. If you have any questions relative to its application DO NOT use the tool until you have written Porter- Cable and we have advised you. Read and understand tool labels and manual. Operator and others in work area MUST wear safety glasses with side shields. Page 5 Fig. Do not use tool without safety warning label.
If label is missing, damaged or unreadable, contact your Porter-Cable Service Center for a replacement. Only use parts, fasteners and accessories approved by Porter-Cable.
Page 6: Technical Specifications Remove finger from trigger when not driving fasteners. Never carry tool with finger on trigger. Do not overreach. Keep proper footing and balance at all times when using or handling the tool. Page 8 Only use approved Porter-Cable fasteners. Never use a tool that is leaking air, has missing or damaged parts, or requires repair. Never point tool at yourself or others. Never attempt to drive a fastener into material that is too hard, or at too steep an angle, or near the edge of the workpiece.
Screw,Soc Hd. Cap M5 X Nut,Esn M6X1. Nailer Parts. Repair Guides Power Tool Care and Maintenance This article suggests guidelines for power tool care and maintenance. My framing gun is leaking from back where the plastic and the aluminum housing meets what do I need to fix the air leak.
Jason for model number FrB asked on Hello Jason, thank you for your inquiry! Did this question help you? Yes No. Hello repair team, The framing nail gun has a hissing from the trigger. Sometimes it will fire good, but most often will not fire off. Do I need to replace all prongs within the trigger assembly? Also often the trigger pin will not retract after firing. Is this gun a type 1 or 2. Thanks, Phil Model FR serial Phil for model number Model FR asked on Hi Phil, Thank you for your question.
If you are hearing a hissing sound when you engage the trigger, this is air escaping. The cause for this is that the o-rings are not sealing properly. O-rings can wear out over time and they will need to be replaced. The part numbers for the o-rings to check are, , , , , , and These o-ring can also be purchased with the trigger valve assembly, part number A I hope this helps. Thank you and have a great day!
John for model number FRB asked on Hi John, we do not understand what you are asking here you wrote "aprox. Can you resubmit your questions with a bit more detail? Thank you for your question and good luck with your repair! What is the solution?
0コメント